 |
|
| DISPLAYWALL » FAQS | |
 |
|
| » Enquiry Form | « Back | |||
 |
||||
Are there any minimum orders? There are no minimum orders, however please balance your order size with the cost of freight and transport, or you may opt to pick up your order at our Carrington Warehouse. What are some guidelines to installing designwall panels? Tools that are needed are regular carpenter tools for installation, including a hammer, saw, leveller, block plane, sanding block, drill, screw and nail sets. You will need turps to clean up adhesive. Open packaging and inspect all panels. If material is defective or does not comply with your order please ring us immediately. Unless the panels are moisture resistant, they need to be stored in a dry environment. Before installation, arrange the panels on each wall to achieve the best combination of colour and pattern. Cut panels to size with the blade entering the grooved side of the panel to avoid panel damage. Panel adhesive can be used for permanent installations. Install the panels over existing plaster or drywall onto studs. Drywall screws of the proper length work the best. Drive the screws through the backs of the groove and be careful not to damage the groove lips. For maximum load level capacities, screws should be driven through every second or third groove. Once installed the panels can be easily cleaned with a soft, slightly damp cloth and a mild soap or ammonia rich liquid cleaner. |
||||